If your Tecno Pova 6 Neo (Li6) is completely dead and not booting up, stuck in 9008 mode, or not responding after flashing, then flashing a working Easy-JTAG Dump File is one of the most effective methods to revive your device.
This post contains a tested full dump file from a working unit, compatible with Easy-JTAG Box, ideal for repairing dead boot, EMMC/UFS corruption, and other hardware-level issues.
📱 What Is Included in the Dump File?
This full partition backup includes:
-
preloader
-
boot
-
recovery
-
system/vendor
-
vbmeta, dtbo
-
md1img, nvram, nvdata
-
userdata, and more.
You can use these partitions to restore the internal storage structure of your Tecno Pova 6 Neo (Li6) and recover it from a dead state.
⚙️ When to Use This Dump File:
-
After a failed OTA update or flash that caused boot failure
-
Phone stuck in MTK USB Port / Brom mode / 9008 mode
-
No display or not charging
-
Full dead boot due to partition damage
-
Data corruption or write protection issues on UFS/EMMC
🔧 How to Use (via Easy-JTAG):
-
Open the device and locate the EMMC/UFS test points or use a socket adapter if available.
-
Connect to Easy-JTAG or UFI Box with the correct voltage and configuration.
-
If possible, backup partitions like
nvram,nvdata, andpersistto preserve IMEI and other unique data. -
Load the Li6 Dump File in Easy-JTAG software.
-
Write the required partitions or full dump depending on the issue.
-
Disconnect, reassemble the phone, and power on.
-
Optionally, flash official firmware after dump restore.
⚠️ Important: Always backup security files before flashing. If these files are lost, you may lose IMEI, resulting in no network/no baseband.
📥 Download Now:
👉 Tecno Pova 6 Neo (Li6) Easy-JTAG Dump File
This dump file has been successfully tested by expert technicians and is shared for professional repair use. If you find this helpful or face any issue, join the discussion on Tech Fix Forum and connect with the repair community.
Need help or pinout info? Drop a comment or start a thread in the forum!