If your Redmi A2+ (codename: water) is completely dead, stuck on the logo, or not booting due to a failed flash or corrupted firmware, then this 100% tested full dump file is the solution you need. This dump was read using UnlockTool and includes all essential partitions needed to bring your device back to life.
This file is especially useful for technicians using EMMC/UFS programmers, or for advanced flashing via boot repair tools like UFI, Easy JTAG, Hydra, or UnlockTool.
📱 Device Info:
-
Device Name: Redmi A2+
-
Codename: water
-
Chipset (CPU): MediaTek Helio G36 (MT6765H)
-
Storage Type: eMMC
-
Boot Mode: Preloader / BROM Mode
-
Tool Used: UnlockTool
-
Dump Format: Partition-wise Full Dump
🔧 When to Use This Dump File:
-
Device is totally dead (no boot, no recovery).
-
Stuck on boot logo or fastboot mode.
-
Corrupted or missing partitions such as preloader, lk, boot, vbmeta, system, or userdata.
-
Device entered brick state after wrong firmware flash.
-
You need to recover partitions via ISP pinout or direct eMMC flashing.
⚠️ Important Note:
Always backup NVRAM, NVDATA, and IMEI partitions before flashing this dump file.
Flashing dump files without security backup may result in IMEI loss, baseband unknown, or no network issues.
✅ Flashing Instructions:
-
Extract the downloaded dump file.
-
Open UnlockTool, UFI, or any other supported tool.
-
Select the proper MT6765/Helio G36 chipset settings.
-
Load and write the required partitions or full dump.
-
Connect the phone in Preloader mode (Volume + and Volume – while inserting USB).
-
Begin the flashing or writing process.
-
After successful flash, reboot the device.
-
If necessary, flash official firmware or restore security backups.
📥 Download Link:
🔗 Redmi A2+ (Water) Full Dump File – Free Download (TechFixForum)
📢 Stay Connected:
Get more tested files, tools, and repair guides free at TechFixForum.com