If your Realme C61 (Model: RMX3930) is dead, stuck on the boot logo, or bricked due to wrong firmware flashing, this tested Scatter Dump File, read via UnlockTool, can help restore the device.
It is especially useful for repairing dead boot issues through ISP or BROM (Preloader) mode.
📱 Device Specifications:
-
Model Name: Realme C61
-
Model Number: RMX3930
-
Chipset (CPU): Unisoc T612 (Spreadtrum)
-
Storage Type: eMMC
-
Boot Mode: Preloader / BROM Mode
-
Dump Format: Scatter Partition File
-
Tool Used: UnlockTool
-
Status: Fully Tested & Verified
🔧 Use Case Scenarios:
-
Device is completely dead or not turning on
-
Stuck on Realme logo, bootloop, or fastboot mode
-
Partition damage after a wrong firmware flash
-
EMMC or ROM level repair using ISP pinout
-
Fixing partitions like preloader, nvram, lk, system, and userdata
⚠️ Important Note Before Flashing:
Always backup security partitions such as NVRAM, NVDATA, and IMEI before flashing.
If these are lost, the device may face IMEI loss, baseband unknown, or no network issues.
✅ Flashing Instructions:
-
Extract the dump file on your computer.
-
Open UnlockTool and go to the Unisoc section.
-
Load the Unisoc scatter file from the dump folder.
-
Connect the device in Preloader/BROM mode (usually Volume Down + USB) or via ISP method.
-
Select and flash required partitions or full dump as needed.
-
Once flashed, disconnect and power on the phone.
Optional: After dump flashing, you can install full stock firmware for complete software recovery and stability.
📥 Download Link:
🔗 Realme C61 (RMX3930) Scatter Dump File – Free Download (TechFixForum)