Realme 9 Pro Plus (RMX3392) is dead, stuck in a boot loop, or has corrupted UFS storage, this 100% tested UFS dump file can help you repair your device. The dump file is read using Easy JTAG Box and supports UFI Box, MIPI Tester, and other UFS flashing tools.
File Details
Device: Realme 9 Pro Plus
Model: RMX3392
Chipset: MediaTek Dimensity
Storage Type: UFS
File Type: Full Dump File (Boot Repair & Partition Backup)
Uses: Dead Boot Repair, UFS Restoration, Partition Recovery
Read By: Easy JTAG Box
Supported Tools: Easy JTAG, UFI Box, MIPI Tester
Issues Fixed with This Dump File
Dead Boot Repair
Boot Loop / Stuck on Logo Fix
Corrupted UFS Storage Repair
Fix Partition Errors & Missing Partitions
Restores Boot, System, Vendor & Other Key Partitions
How to Use Realme 9 Pro Plus Dump File?
Requirements:
Windows PC with UFS Flasher
Easy JTAG Box, UFI Box, or MIPI Tester
Realme 9 Pro Plus UFS Chip (Desoldered if Needed)
Correct UFS IC Adapter
Flashing Instructions:
Backup Security Files
- Before flashing, back up security partitions to avoid losing IMEI and other critical data.
Remove UFS Chip (if necessary)
- If the device is completely dead, remove the UFS chip using a hot air station.
Connect UFS Chip to Easy JTAG/UFI Box
- Place the UFS chip in the UFS adapter and connect it to Easy JTAG, UFI Box, or MIPI Tester.
Load the Dump File
- Select the correct UFS IC model and load all required partitions (Boot, System, Vendor, etc.).
Write Dump File to UFS Chip
- Flash the dump file carefully and verify partitions after writing.
Reinstall the UFS Chip
- Carefully resolder the UFS chip back onto the motherboard.
Power On & Test
- Boot the device and flash stock firmware if necessary.
Note: If the security partition was erased, IMEI repair is required separately.
FAQs (Frequently Asked Questions)
1. What is this dump file used for?
This UFS dump file is used for dead boot repair, fixing boot loops, and restoring corrupt partitions in Realme 9 Pro Plus (RMX3392).
2. Can I flash this file using QFIL or SP Flash Tool?
No, this is a UFS dump file, not a firmware package. It must be flashed using Easy JTAG, UFI Box, or MIPI Tester.
3. Does this file fix IMEI issues?
IMEI can only be restored if you backed up security partitions before flashing. Otherwise, manual IMEI repair is required.
4. Will flashing this dump file erase my data?
Yes, flashing will erase all data. Make sure to back up important files before proceeding.